Search the Tone Freq blog!

Top Stories

Tuesday, May 4, 2010

Keith Urban talks Nashville flood with CNN

Keith Urban got on Skype earlier this afternoon to talk with CNN's Rick Sanchez about the Nashville flood. Sanchez seemed more interested in talking about Urban's own equipment losses (at the flooded Soundcheck rehearsal studios), but Urban was quick to counter that there are much bigger problems in the area.

“I went through this in Australia in 1974," he said. I was very young, but we had this kind of 100-year flood in my city, and it’s just unfathomable. As someone said this morning, you know, when you see it in other places, like we saw in New Orleans, you feel for these people, but you don’t get a sense of what it’s like until it happens to your own city.”

READ MORE

Thanks for reading,
Aljon

Follow me on Twitter! @aljonrocks
Follow ToneFreq.info for daily guitar gear updates!
Posted by at 11:05 PM
Labels: , , , ,

1 comment:

  1. UnknownMay 5, 2010 at 7:04 AM

    Nashville Flood: Initial Steps to Take When Recovering Your Guitar Amp

    I am an amp builder/designer based in Franklin/Nashville TN. I was lucky enough to be on high ground, about 100 yards from the flood water. Others were less fortunate. If your prized amplifier(s) have been damaged, take these initial steps:

    NOTE: Take steps to handle your gear in a sanitary manner (rubber gloves, etc.). Keep in mind that your amp has been submerged in likely contaminated water (chemicals, microbes, waste and other yuck).
    NOTE: Do NOT spray your gear off with a hose... it's wet already isn't it? While it is already wet, spraying it off will likely cause more damage by forcing water or contaminants deeper into the circuitry.

    • Oxygen and high-humidity are not your amp's friend after a flood - they're responsible for bringing on rust. Rust is corrosion and will expand and cause all kinds of damage. We need to take immediate action to dry out these amplifiers once they're recovered from the flood site.
    • I'd get the most prized pieces of gear disassembled immediately (like in the parking lot once they let you on site) and get the chassis toweled dry. Then wrap it in a dry towel and get it home asap and place it in an air-conditioned room.
    • Blast the AC and put the gear near the vent. The goal here is to get the chassis in a low-humidity environment. This will keep corrosion down to a slower pace.
    • If you have one, use a wet-vac and vacuum out additional water.

    We now have some time to get the transformers out and get them dry. I've discussed the situation with Mercury Magnetics and they've pledged to assistance with re-baking transformers. If a transformer is too severely damaged, they'll rewind or provide replacements at reduced cost for Nashville musicians impacted by the flood.

    In any case, do not power the amp on even if it looks like it's dry as it needs to be examined carefully first. Many vintage and high-end amps have cloth insulated wires. Once they've become compromised by moisture they can no longer effectively insulate and block or retain heat. They'll need to be examined and serviced accordingly.

    Let me know if I can help further.
    __________________
    Jamie Scott
    Tone fanatic and amp designer
    3RD POWER Amplification
    http://www.3rdpoweramps.com
    http://www.myspace.com/jscottvain

    ReplyDelete

Subscribe to: Post Comments (Atom)
Related Posts Plugin for WordPress, Blogger...